Effective and selective aerobic oxidation of primary and secondary alcohols using CoFe2O4@HT@Imine‐CuII and TEMPO in the air atmosphere

In this study, we present a versatile and easy procedure for modifying a cobalt ferrite nanoparticle step by step. A new nanocatalyst was prepared via Cu^II immobilized onto CoFe₂O₄@HT@Imine. The catalyst was fully characterized by Fourier‐transform infrared (FT‐IR), energy‐dispersive X‐ray spectroscopy (EDX), field emission scanning electron microscopy (FE‐SEM), X‐ray diffraction (XRD), and vibrating sample magnetometer (VSM) analyses. The current procedure as a green protocol offers benefits including a simple operational method, an excellent yield of products, mild reaction conditions, minimum chemical wastes, and short reaction times. Without any significant reduction in the catalytic performance, up to five recyclability cycles of the catalyst were obtained. The optimization results suggest that the best condition in the oxidation of benzyl alcohol derivatives is 0.003 g of the CoFe₂O₄@HT@Imine‐Cu^II catalyst, TEMPO, at 70°C under solvent‐free condition and air.     

气体压强对纳秒激光诱导空气等离子体特性的影响

环境气体的压强对激光诱导等离子体特性有重要影响.基于发射光谱法开展了气体压强对纳秒激光诱导空气等离子体特性影响的研究,探讨了气体压强对空气等离子体发射光谱强度、电子温度和电子密度的影响.实验结果表明,在10-100 kPa空气压强条件下,空气等离子体发射光谱中的线状光谱和连续光谱依赖于气体压强变化,且原子谱线和离子谱线强度随气体压强的变化有明显差别.随着空气压强增大,激光击穿作用区域的空气密度增加,造成激光诱导击穿空气几率升高,从而等离子体辐射光谱强度增大.空气等离子体膨胀区域空气的约束作用,增加了等离子体内粒子间的碰撞几率以及能量交换几率,并且使离子-电子-原子的三体复合几率增加,因此造成原子谱线OⅠ777.2 nm与NⅠ821.6 nm谱线强度随着气体压强增大而增大,在80 kPa时谱线强度最高,随后谱线强度缓慢降低.而离子谱线N Ⅱ 500.5 nm谱线强度在40 kPa时达到最大值,气体压强大于40 kPa后,谱线强度随压强增加而逐渐降低.空气等离子体电子密度均随压强升高而增大,在80 kPa后增长速度变缓.等离子体电子温度在30 kPa时达到最大值,气体压强大于30 kPa后,等离子体电子温度逐渐降低.研究结果可为不同海拔高度的激光诱导空气等离子体特性的研究提供重要实验基础,为今后激光大气传输、大气组成分析提供重要的技术支持.     

风力机叶片气动噪声的影响参数*

随着风力机的大型化，风电机组对环境的影响不容忽视，必须对风力机气动噪声进行预测和控制。选取基于NACA、DU翼型的某风力机叶片作为研究基准，采用修正BPM半经验模型计算叶片的气动噪声特性，通过改变翼型族、弦长、机组运行状态、风切变指数、来流风向参数，研究叶片外形几何参数、机组运行工况对叶片气动噪声源的影响。计算结果从多个角度总结出水平轴风力机叶片气动噪声的变化规律，为开发高效低噪风电叶片提供参考。     

Flume testing of passively adaptive composite tidal turbine blades under combined wave and current loading

The tidal energy industry is progressing rapidly, but there are still barriers to overcome to realise the commercial potential of this sector. Large magnitude and highly variable loads caused by waves acting on the turbine are of particular concern. Composite blades with in-built bend-twist elastic response may reduce these peak loads, by passively feathering with increasing thrust. This could decrease capital costs by lowering the design loads, and improve robustness through the mitigation of pitch mechanisms. In this study, the previous research is extended to examine the performance of bend-twist blades in combined wave–current flow, which will frequently be encountered in the field. A scaled 3 bladed turbine was tested in the flume at IFREMER with bend-twist composite blades and equivalent rigid blades, sequentially under current and co-directional wave–current cases. In agreement with previous research, when the turbine was operating in current alone at higher tip speed ratios the bend-twist blades reduced the mean thrust and power compared to the rigid blades. Under the specific wave–current condition tested the average loads were similar on both blade sets. Nevertheless, the bend-twist blades substantially reduced the magnitudes of the average thrust and torque fluctuations per wave cycle, by up to 10% and 14% respectively.     

A sensitive and efficient method for trace analysis of some phenolic compounds using simultaneous derivatization and air‐assisted liquid–liquid microextraction from human urine and plasma samples followed by gas chromatography–nitrogen phosphorous detection

In present study, a simultaneous derivatization and air‐assisted liquid–liquid microextraction method combined with gas chromatography–nitrogen phosphorous detection has been developed for the determination of some phenolic compounds in biological samples. The analytes are derivatized and extracted simultaneously by a fast reaction with 1‐flouro‐2,4‐dinitrobenzene under mild conditions. Under optimal conditions low limits of detection in the range of 0.05–0.34 ng mL^?1 are achievable. The obtained extraction recoveries are between 84 and 97% and the relative standard deviations are less than 7.2% for intraday (n = 6) and interday (n = 4) precisions. The proposed method was demonstrated to be a simple and efficient method for the analysis of phenols in biological samples. Copyright © 2015 John Wiley & Sons, Ltd.     

基于LBM方法的风力发电机尾流结构仿真

针对传统CFD数值计算方法难以实现风力机动态旋转及其旋转状态下的流固耦合计算,本文结合格子玻尔兹曼(LBM)方法易于处理动态复杂边界的特点及大涡模拟(LES)方法在非稳态涡流结构捕捉上的优势,采用LBM-LES联合方法进行三维风力发电机整机气动性能及尾流结构仿真研究,同时采用尺度自适应方法对尾涡结构进行跟踪和精细化计算。针对NREL PhaseⅥ型试验机进行模拟,得到了与实验结果吻合的流动形态及尾流结构演变规律,分析了尾流区速度演变规律并对比了不同亚格子湍流模型对计算结果的影响.     

燃气透平叶片表面颗粒沉积特性数值研究进展

污染物颗粒在燃气透平叶片表面及冷却通道内的沉积将影响透平叶片的冷却特性和安全服役寿命。国外许多研究机构对燃气透平叶片表面污染物颗粒沉积特性及其与叶片气膜冷却的相互作用机制进行了持续研究。本文首次系统总结了近年来燃气透平叶片表面污染物颗粒沉积特性数值研究进展,重点介绍了燃气透平叶栅流道内污染物颗粒的沉积机制、颗粒沉积和脱离物理模型以及颗粒沉积与透平叶片冷却特性相互作用的数值模拟方法和研究成果。基于当前研究热点和发展趋势,结合作者的研究经历,指出了国内在研发先进燃气轮机透平冷却结构时应注意的问题和方向,为高效、燃料适应性更广的燃气轮机技术自主开发奠定基础。     

基于显示连通贝叶斯网络的机场塔台地震易损性分析

将基于性能的多维易损性分析方法,结合显示连通贝叶斯网络,应用于机场塔台的多维易损性分析。考虑地震激励的不确定性,通过非线性时程分析获得结构响应数据;将塔台结构分为三个层次,每个层次按包含的层数分为相应的子层次。根据功能特性确定子层次的评价指标和极限状态,建立服从多元对数正态分布的概率地震需求模型;考虑各种极限状态之间的相关性,建立极限状态方程,确定失效域,通过蒙特卡洛法求得构件的超越概率;建立塔台结构的显示连通贝叶斯网络模型,利用层次分析法获得中间节点的条件概率表,利用MATLAB进行贝叶斯网络的推理计算,实现从单一层次的易损性到整体易损性的推理。     

微波瑞利散射法测定空气电火花激波等离子体射流的时变电子密度

大气压空气电火花激波等离子体射流的电子密度在亚微秒时间尺度上瞬变,其电子密度的测定很难.基于微波瑞利散射原理,本文测量了空气电火花冲击波流注放电等离子体射流的时变电子密度.实验结果表明:测量系统的标定参数A为1.04 × 105 V·Ω·m–2;空气流注放电等离子体射流的电子密度与等离子体射流的半径和长度有关,结合高速放电影像展示的等离子体射流的等效半径和等效长度,测定的电子密度在1020 m–3的量级,且随时间先快速增长至峰值再成指数衰减.此外,本文还探讨了等离子体射流的不同等效尺度对测定结果的影响;分析结果表明,采用时变等效半径和时变等效长度的计算结果最有效,且第1个快速波峰是由光电离的电离波导致的.     

顶空气相色谱法测定工作场所空气中的乙酸乙酯

采用顶空气相色谱法测定工作场所空气中的乙酸乙酯。气态乙酸乙酯用活性炭管吸附,二氯甲烷解吸,顶空进样,HP–FFAP毛细管柱分离,FID检测器测定,峰面积定量。乙酸乙酯的质量浓度在1.76~880.0μg/m L范围内与色谱峰面积呈良好的线性,相关系数r=0.999 4。不同浓度样品批内测定结果的相对标准偏差为1.34%~3.61%(n=7),批间测定结果的相对标准偏差为1.04%~4.78%(n=7),加标回收率为91.02%~100.29%,方法检出限为0.32μg/m L,解吸效率为91.28%~95.19%。对于100 mg活性炭,乙酸乙酯的穿透容大于2.2 mg,当其浓度在17.6~17 600 mg/m3时,采样效率为91.23%~97.40%,常温下可以保存10 d。该方法各项指标均达到《工作场所空气中有毒物质检测方法研制规范》的要求,适用于工作场所空气中乙酸乙酯的现场监测。